Powder Coating Services
Powder
Coating Plus offers
complete Powder Coating services in our state-of-the-art facility.
Our production line consists of a four-stage parts washer, four powder spray stations and a curing oven. Parts travel through the process on an automated variable-speed 700 foot conveyer.
Parts
Cleaning
A major factor in obtaining good powder
adhesion is to make sure that the surface is
properly prepared. In some cases this will
include being media blasted (commonly
referred to as sandblasting). This process
will remove all layers of color and rust. It
will assist your product in having a good
permanent bond between the substrate
material and the applied powder coat. This
step helps ensure a long lasting and durable
finish that you will be proud of for years to
come.
We start by cleaning your parts. We offer both chemical and sandblast cleaning to meet your needs. We use only conditioned reverse-osmosis water to ensure your parts have an ideal surface to which the finish will firmly bond.
Our
solutions are electronically monitored. The phosphatizer
and cleaning chemicals 
are
individually dispensed by computer
control. In addition, we also monitor the chemical balance, PH,
and cleanliness of
our tanks. This
not only ensures
that our
monitoring and
dispensing
systems are
functioning
correctly, but also
provides a
separate analysis
of our system as
well as a history of
our process. These double checks provide you, the customer,
with the knowledge that our system is operating within good
business practices and your product will be processed under the
most optimal conditions possible.
We also have a Burn-off oven. We can safely remove old and discolored finishes from your parts without using abrasives.
Powder
Coating
Then parts receive an electrostatic charge that causes the powder to be drawn to the surface and to firmly adhere once attached. Our spray-to-waste booths allow quick color changes to save you money on shorter production runs while our spray-to-reclaim booths allow the over-sprayed powder to be reclaimed on larger production runs. This results in a lower cost to produce your part.
State-of-the-art
electronic controls
maintain wash temperatures, water
flow, moisture venting, conveyer
speed, and stable oven temp-eratures
to ensure a consistent and durable
cure.
Parts
that are too large to run on the
conveyer system can have the powder coating
cured in one of our batch ovens.
Silk Screening
Experience the advantage of having your parts chemically cleaned, sandblasted if necessary, powder coated, and then silk-screened in multiple colors with your company logo and other information with only one phone call. Let us be your one-stop-shopping source for all your part-finishing needs.
